|Availability:||In stock (2)|
SPANISH HEMSTITCH FOOT
For sewing machines:
DESIGNER DIAMOND™ series, DESIGNER RUBY™ series,
DESIGNER TOPAZ™ series, SAPPHIRE™ series,
OPAL™ series, EDEN ROSE™ 250C, TRIBUTE™ 140C.
Spanish Hemstitching is a delightful addition to any project. It is used
to join two fi nished edges. It works well to attach borders, edging to
a skirt or curtain or to piece fabric, for example to achieve the width
needed for a tablecloth. For the above models, the Spanish Hemstitch
Distance Plate snaps on to the standard needle plate.
1. Snap the Distance Plate onto the needle plate by placing the little prongs into the holes in the
plate. Be sure that the plate doesn't cover the feed teeth. Snap on the Spanish Hemstitch Foot.
2. Thread with a decorative thread on top and in the bobbin.
3. Select a zigzag, three step zig zag. Adjust stitch width to make sure that the needle catches
the fabric edges. Note: Avoid using stitches with too much side motion and stitches with too
much motion forward and back.
4. You need to have a fi nished edge. If necessary, press under a 3/8" (1 cm) seam allowance on the
fabric edges that will be stitched together.
5. Place the pressed edge of the pieces on each side of the Distance Plate.
6. Lower the presser foot.
Start with a long thread tail of both top and bobbin thread. Hold these threads as you begin
sewing until the needle catches on the fabric. Because of the nature of the stitching, it will stitch
on "œair" for several stitches before it goes over and catches the fabric edge. Once the needle has
caught the fabric, you can let go of the threads. Sew, holding the edges gently together in front of
the foot. Optional: Place a decorative thread in the groove of the Distance Plate.